9
Safety Precautions Document
OMNUC G5-Series AC Servo Drives Users Manual (Built-in MECHATROLINK-II communications type)
Storage and Transportation
Use the motor and Servo Drive in the specified combination.
Fire or equipment damage may result.
Do not store or install the product in the following environment:
Location subject to direct sunlight
Location where the ambient temperature exceeds the specified level
Location where the relative humidity exceeds the specified level
Location subject to condensation due to the rapid temperature change
Location subject to corrosive or flammable gases
Location subject to higher levels of dust, salt content or iron dust
Location subject to splashes of water, oil, chemicals, etc.
Location where the product may receive vibration or impact directly
Installing or storing the product in these locations may result in fire, electric shock or
equipment damage.
The Servo Drive radiator, Regeneration Resistor, motor, etc. may become hot while the
power is supplied or remain hot for a while even after the power supply is cut off. Never touch
these components.
A burn injury may result.
When transporting the product, do not hold it by the cables or motor shaft.
Injury or failure may result.
Do not overload the products. (Follow the instruction on the product label.)
Injury or failure may result.
Use the motor eye-bolts only when transporting the motor.
Do not use them to transport the machine.
Injury or failure may result.
To Next Page
Loading...
Need help?
General
