Omron R88D-KN ML2 Sries - Page 301

OMNUC G5-Series AC Servo Drives Users Manual (Built-in MECHATROLINK-II communications type)
8
This chapter explains the set value and contents of setting of each parameter.
8-1 Basic Parameters..........................................................8-1
8-2 Gain Parameters ...........................................................8-7
8-3 Vibration Suppression Parameters...........................8-19
8-4 Analog Control Parameters .......................................8-24
8-5 Interface Monitor Setting Parameters.......................8-30
8-6 Extended Parameters .................................................8-41
8-7 Special Parameters.....................................................8-52
Parameters Details