Omron SYSDRIVE 3G3JV

2-28
2-2-6 Conforming to EC Directive
The following description provides the wiring method of the Inverter to meet DC Direc-
tive requirements. If the following requirements are not satisfied, the whole equipment
incorporating the Inverter will need further confirmation.
H Standard Connection
D Main Circuit Terminals
MCCBs
Noise Filter
Clamp core
3-phase 200 V AC
Single-phase 200 V AC
3-phase 400 V AC
D Control Circuit Terminals
Forward/Stop
Multi-function input 1 (S2)
Multi-function input 2 (S3)
Multi-function input 3 (S4)
Multi-function input 4 (S5)
Sequence input common
Frequency reference power
supply at +12 V
FREQ
adjuster
Frequency reference input
Frequency reference common
Multi-function contact output
NO
NC
Common
Analog-monitor output
Analog monitor output common
(2 kΩ, 1/4 W min.)
Note I/O signals can be connected to a single shielded cable.
Design Chapter 2