3-4
Set n01 (Parameter Write-prohibit Selection/Parameter Initialization) to 5.
Note 1. The default setting for n01 is 1.
Note 2. As an exception, operation commands are not received when n01 itself is being changed.
Note 3. Some parameters can be changed during operation and other parameters cannot. This is not
affected by the setting of n01. If the setting for n01 has been changed to 5, operation com-
mands will be received even while parameters are being changed, such as during testing.
Sufficiently check safety before operation.
Preparing for Operation and Monitoring Chapter 3
To Next Page
Loading...
