3-9
Note 1. To cancel the set value, press the Mode Key instead. The parameter number will be dis-
played.
Note 2. There are parameters that cannot be changed while the Inverter is in operation. Refer to the
list of parameters. When attempting to change such parameters, the data display will not
change by pressing the Increment or Decrement Key.
Note 3. Any RUN command input will be ignored while the Parameter Setting (PRGM) indicator is lit.
To enable a RUN command, first turn the RUN command OFF and then press the Mode Key
to display an item that has a green indicator (FREF to MNTR). Then input the RUN command
again.
Preparing for Operation and Monitoring Chapter 3
To Next Page
Loading...
