13 SNMP Agent
13-12
NJ/NX-series CPU Unit Built-in EtherNet/IP Port User’s Manual (W506)
ipAdEn-
tReasmMax-
Size
(5) RO
The maximum IP packet size that can be reas-
sembled from IP fragmented input IP datagrams
received through the interface.
Sup-
ported.
According to the
standard.
ipRouteTable (21) NA
The IP routing table for this entity.
--- ---
ipRouteEntry (1) NA
Route information for a specific destination.
The index is ipRouteDest.
--- ---
ipRouteDest (1) RW
The destination IP address for this route. A value
of 0.0.0.0 for this entry indicates the default route.
Sup-
ported.
According to the
standard.
ipRouteIfIndex (2) RW
The ID number of the interface required to send to
the next destination host in this route. This ID
number is the same number as ifIndex, which is
used to identify the interface.
Sup-
ported.
According to the
standard.
ipRouteMetric1 (3) RW
The primary routing metric for this route. This
value is determined based on the protocol speci-
fied in ipRouteProto. Set to -1 if you do not want to
use this metric (this is also the same for ipRoute-
Metric 2 through 4).
Sup-
ported.
According to the
standard.
ipRouteMetric2 (4) RW
The alternative routing metric for this route.
Sup-
ported.
According to the
standard.
ipRouteMetric3 (5) RW
The alternative routing metric for this route.
Sup-
ported.
According to the
standard.
ipRouteMetric4 (6) RW
The alternative routing metric for this route.
Sup-
ported.
According to the
standard.
ipRouteNext
Hop
(7) RW
The IP address of the next hop in this route (for
routes connected by a broadcast or media, this is
the agent address or address of that interface).
Sup-
ported.
According to the
standard.
ipRouteType (8) RW
The type of route.
Other (1): Not any of the following types.
Invalid (2): An invalid route.
Direct (3): A direct connection.
Indirect (4): An indirect connection (not con-
nected to LOCAL).
Sup-
ported.
According to the
standard.
Subtree name Standard [(identifier) attribute] Support
Implementation
specifications