Onkyo TX-NR545 - Remote Controller; Remote ID; Remote Mode

7.RemoteController
RemoteID
DefaultValue:1
SelectanIDfortheunit'sremotecontrollerfrom"1","2",and"3"to
preventinterferencebetweentheunitandotherOnkyocomponents
thatareinstalledinthesameroom.AfterchangingtheIDonthemain
unit,changetheIDontheremotecontrolleraccordinglywiththe
followingprocedure.
1. WhileholdingdownRECEIVER,pressandholdSETUPforabout3
secondsuntiltheremoteindicatorlights.
2. Withthenumberbuttons,pressoneof1,2,and3.Theremote
indicatorflashestwice.
RemoteMode
DefaultValue:–
Inputandregistertheremotecontrollercodeofotherdevices.
 Forregistrationoftheremotecontrolcode,referto"OperatingOther
ComponentswiththeRemoteController".
Advanced Settings (Setup Menu)