Onkyo TX-NR545 - Network; Wi­fi; Wi­fi Setup; Wi­fi Status

mode,whereonlytheessentialcircuitisoperating.
 Thissettingisfixedto"Off"if"Bluetooth""AutoInputChange"is
setto"Off".
 Waitforawhileif"NetworkStandby"or"BluetoothWakeup"cannotbe
selected.Itwillappearwhenthenetworkfunctionisstartedup.
Network
Makethenetworksetting.
 WhenLANisconfiguredwithaDHCP,set"DHCP"to"Enable"to
configurethesettingautomatically.("Enable"issetbydefault)Toassign
fixedIPaddressestoeachcomponents,youmustset"DHCP"to
"Disable"andassignanaddresstothisunitin"IPAddress"aswellasset
informationrelatedtoyourLAN,suchasSubnetMaskandGateway.
WiFi
DefaultValue:Off(Wired)
ConnecttheunittonetworkviawirelessLANrouter.
"On":WirelessLANconnection
"Off(Wired)":WiredLANconnection
WiFiSetup
DefaultValue:–
YoucanconfigurewirelessLANsettingsbypressingENTERwhen
"Start"isdisplayed.
WiFiStatus
DefaultValue:–
Theinformationoftheconnectedaccesspointwillbedisplayed.
"SSID":SSIDoftheconnectedaccesspoint.
"Signal":Signalstrengthoftheconnectedaccesspoint.
"Status":Statusoftheconnectedaccesspoint.
MACAddress
DefaultValue:–
ThisistheMACaddressoftheAVreceiver.
Thisvalueisspecifictothecomponentandcannotbechanged.
DHCP
DefaultValue:Enable