Onkyo TX-NR545 - Cooling Fan Operation

DefaultValue:No
Setwhetheryourfrontspeakerconnectionisbiamp.
"No":Whenfrontspeakersareconnectedinanormalmanner
"Yes":Whenfrontspeakersarebiampconnected
 Ifanitemcannotbeselectedeventhoughconnectioniscorrect,
checkthatthesettingsin"SpeakerChannels"matchesthenumber
ofconnectedchannels.
PoweredZone2
DefaultValue:No
SettheconnectionofspeakerstoZone2speakerterminals.
"Yes":WhenspeakersareconnectedtoZONE2speakerterminals
"No":WhenspeakersarenotconnectedtoZONE2speakerterminals
 Thisitemwillbesetto"No"when"BiAmp"issetto"Yes".
Crossover
Allowsyoutochangespeakerconfigurations,suchascrossoverfrequency.
SettingsareautomaticallyconfiguredifyouusetheAutomaticSpeaker
Setup.Audiowillnotbeoutputwhileyouaremakingthissetting.
Front
DefaultValue:100Hz
Selectthecrossoverfrequencyfrom"40Hz"to"200Hz"tostart
outputtingfrequenciesforeachchannel.
"FullBand":Fullbandwillbeoutput.
 If"Configuration""Subwoofer"issetto"No","Front"willbefixedto
"FullBand"andthelowpitchedrangeoftheotherchannelswillbe
outputfromthefrontspeakers.Refertotheinstructionmanualof
yourspeakerstomakethesetting.
Center
DefaultValue:100Hz
Selectthecrossoverfrequencyfrom"40Hz"to"200Hz"tostart
outputtingfrequenciesforeachchannel.
"FullBand":Fullbandwillbeoutput.
 "FullBand"canbeselectedonlywhen"Front"issetto"FullBand".
 Ifanitemcannotbeselectedeventhoughconnectioniscorrect,
checkthatthesettingsin"Configuration""SpeakerChannels"
matchesthenumberofconnectedchannels.
Height
DefaultValue:100Hz