Onkyo TX-NR545 - RI Connection and Setting; Rename the Input Selector; To Program the RI Remote Control Code

RIConnectionandSetting
ConnectanOnkyocomponentwithRIjacktothisunitusinganRIcableand
ananalogaudiocable.Fordetails,refertotheinstructionmanualofthe
componentwithRIjack.TheRIcablecanbeconnectedinanyorder.When
therearetwoRIjacks,bothjacksworkinthesamewayandare
interchangeable.
ToconnecttheRIDockorcassettetapedeckviaRI,thefollowingsettings
arerequired.
Renametheinputselector
TomaketheRIfunctionswork,youmustrenametheinputselectorsonthe
unit.PressCDorGAMEtodisplay"CD"or"GAME"onthemainunitdisplay.
ThenpressandholdCDorGAME3secondsormoretoswitchthedisplay
to"DOCK"or"TAPE".
ToprogramtheRIremotecontrolcode
ProgramtheremotecontrolcodetoanyREMOTEMODEbuttononthe
remotecontroller.Thiswillallowyoutooperatethecomponentbypointing
theremotecontrollerattheunitinsteadofthecomponent.
1. PressandholdDISPLAYfor3ormoresecondswhileholdingdownthe
REMOTEMODEbuttontowhichyouwanttoprogramtheremotecontrol
code.
Connecting and Operating Onkyo RI Components