Onkyo TX-NR545 - Hardware; Tuner; Hdmi; Hdmi Cec (Rihd)

6.Hardware
Tuner
AM/FMFrequencyStep(NorthAmericanandTaiwanesemodels)
DefaultValue:10kHz/0.2MHz
Selectafrequencystepdependingonyourareaofresidence.
Select"10kHz/0.2MHz"or"9kHz/0.05MHz".
 Whenthissettingischanged,allradiopresetsaredeleted.
AMFrequencyStep(European,AustralianandAsianmodels)
DefaultValue:9kHz
Selectafrequencystepdependingonyourareaofresidence.
Select"10kHz"or"9kHz".
 Whenthissettingischanged,allradiopresetsaredeleted.
HDMI
HDMICEC(RIHD)
DefaultValue:Off
Settingto"On"enablestheinputselectionlinkandotherlinkfunctions
withHDMIconnectedCECcompliantdevice.
"On":Usethisfunction
"Off":Donotusethisfunction
Whenchangingthissetting,turnoffandthenonagainthepowerofall
connectedcomponents.
 DependingontheTVset,alinkmayneedtobeconfiguredonthe
TV.
 Whenthissettingis"On",thenamesoftheCECcompatible
componentsand"CECOn"aredisplayedafterthisoperationscreen
isclosed.
 Powerconsumptioninstandbymodemayincreaseifthissettingis
"On".(DependingontheTVstatus,theunitwillenterthenormal
standbymode.)
 IfyouoperatetheMASTERVOLUMEcontrolontheunitwhenthis
settingis"On"andaudioisoutputfromtheTVspeakers,audiowill
Advanced Settings (Setup Menu)