Onkyo TX-NR545 - Source; Intellivolume; Name Edit

4.Source
Makesettingsforinputsources,suchasvolumedifferenceadjustmentsfor
eachinputselectorfortheconnectedequipment.Selecttheinputselectorto
configure.
IntelliVolume
IntelliVolume
DefaultValue:0dB
Adjustthevolumeleveldifferencebetweenthedevicesconnectedto
theunit.Selectavaluebetween"12dB"and"+12dB".Setanegative
valueifthevolumeofthetargetdeviceislargerthantheothersanda
positivevalueifsmaller.Whenyouselectadesiredinputtocheckthe
audio,startplaybackoftheconnecteddevice.
 ThisfunctionisnoteffectiveinZone2.
NameEdit
Setaneasynametoeachinput.Thesetnamewillbeshownonthemain
unitdisplay.Selecttheinputselectortoconfigure.
Name
DefaultValue:Inputname
1. SelectacharacterorsymbolwiththecursorsandpressENTER.
Repeatittoinput10orlesscharacters.
"A/a":Switchesbetweenupperandlowercases.(Pressing+10on
theremotecontrolleralsotogglesbetweenupperandlowercases.)
"←""→":Movesthecursortothearrowdirection.
" ":Removesacharacterontheleftofthecursor.
"Space":Putsaspace.
 PressingCLRontheremotecontrollerwillremovealltheinput
characters.
2. Afterinputting,select"OK"withthecursorsandpressENTER.
Theinputnamewillbesaved.
 Tonameapresetradiostation,pressTUNERontheremotecontroller,
Advanced Settings (Setup Menu)