Onkyo TX-NR545 - Others; Strange Noises Can be Heard from the Unit; The Late Night Function Does Not Work; The Cinema Filter Function Does Not Work

Others
Strangenoisescanbeheardfromtheunit
 Ifyouhaveconnectedanotherunittothesamewalloutletasthisunit,
thisnoisemaybeaneffectfromtheotherunit.Ifthesymptomsimprove
byunpluggingthepowercordoftheotherunit,usedifferentwalloutlets
forthisunitandtheotherunit.
WhenperformingAutomaticSpeakerSetup,themeasurementfailsand
themessage"Ambientnoiseistoohigh."isdisplayed.
 Thiscanbecausedbyamalfunctioninyourspeakerunit.Checkifthe
unitproducesnormalsounds.
TheLateNightfunctiondoesnotwork
 MakesurethesourcematerialisDolbyDigital,DolbyDigitalPlusor
DolbyTrueHD.
TheCinemaFilterfunctiondoesnotwork
 Thisfunctioncanbeusedinthefollowinglisteningmodes:DolbyDigital,
DolbyDigitalPlus,DolbyTrueHD,Multichannel,DTS,DTSES,DTS
Neo:6Cinema,DTS96/24,DTSHDHighResolutionAudio,DTSHD
MasterAudio,DTSExpress,DSD.
HowdoIchangethelanguageofamultiplexsource
 Select"Main"or"Sub"for"3.AudioAdjust""Multiplex/Mono""Multiplex
InputChannel".
CannotconnecttotheAVreceiverfromaWebbrowser
 MakesurethattheIPaddressoftheAVreceiveriscorrectlyinputtothe
Internetbrowser.
 WhenDHCPisusedforallocatingtheIPaddress,theIPaddressofthis
AVreceivermayhavebeenchanged.
 MakesurethatbothAVreceiverandPCareproperlyconnectedtothe
network.
Powerconsumptioninstandbymode
 Inthefollowingcases,thepowerconsumptioninstandbymodemay
reachuptoamaximumof4.4W:
– When"NetworkStandby"in"6.Hardware""PowerManagement"
"Network"issetto"On".
– When"HDMICEC(RIHD)"issetto"On".(DependingontheTV
Troubleshooting