Onkyo TX-NR545 - Connecting and Operating Onkyo RI Components; About RI Function

AboutRIFunction
ConnectinganOnkyocomponentwithRIjacksuchastheseparatelysoldRI
DocktotheunitbyusinganRIcableandananalogaudiocableenablesthe
followingRIfunctions:
SystemOn/AutoPowerOn:Startingplaybackonacomponentconnected
viaRIwhentheunitisonstandbymode,automaticallyturnsontheunitto
selecttherelevantcomponentasitsinputsource.
DirectChange:WhenplaybackisstartedonacomponentconnectedviaRI,
theunitselectsthatcomponentastheinputsource.
RemoteControllerOperation:AllowsyoutooperateRIcompatibleOnkyo
componentsusingtheAVreceiver'sremotecontroller.Pointtheremote
controlleratremotecontrolsensoroftheunit.Thisoperationispossibleonly
whentheRIremotecontrolcodeisprogrammed.
 SomecomponentsmaynotsupportallRIfunctions.
 ThesefunctionsdonotworkwhenZone2isturnedon.
 ForinformationontheRIfunctions,alsorefertoeachcomponent's
instructionmanual.
Connecting and Operating Onkyo RI Components