Onkyo TX-NR545 - Linked Operation; The RI Functions Do Not Work

Linkedoperation
ThereisnoHDMIlinkedoperationwithCECcompliantequipmentsuch
asatelevision
 SettheHDMICEC(RIHD)settingoftheunitto"On".PressRECEIVER
andthenSETUPontheremotecontroller,select"Setup""6.Hardware"
"HDMI""HDMICEC(RIHD)"andsetto"Yes".
 ItisalsonecessarytomaketheHDMIlinkedsystemsettingsonthe
CECcompliantequipment.Checktheoperatinginstructions.
TheRIfunctionsdonotwork
 TouseRI,youmustmakeanRIconnectionandananalogaudio
connection(RCA)betweenthecomponentandAVreceiver.
 WhileZone2isselected,theRIfunctionsdonotwork.
Troubleshooting