Onkyo TX-NR545 - Updating the Firmware Via Network; Before Starting

UpdatingtheFirmwareviaNetwork
BeforeStarting
 Checkthattheunitisturnedon,andtheconnectiontotheInternetis
secured.
 Turnoffthecontrollercomponent(PCetc.)connectedtothenetwork.
 StopanyplayingInternetradio,USBstoragedevice,orservercontent.
 Ifthemultizonefunctionisactive,pressOFFonthemainunittoturnit
off.
 If"HDMICEC(RIHD)"issetto"On",setitto"Off"(defaultvalue).
– AfterpressingRECEIVERontheremotecontroller,pressSETUP.
Then,afterselecting"6.Hardware""HDMI"andpressingENTER,
select"HDMICEC(RIHD)"toselect"Off".
＊ Thedescriptionmaydifferfromtheonscreendisplaybutthatwillnot
changethewaytooperateorthefunction.
Update
1. AfterpressingRECEIVERontheremotecontroller,pressSETUP.
TheSetupmenuisdisplayedontheTVscreen.
Firmware Update