Onkyo TX-NR545 - Updating the Firmware Via USB

UpdatingtheFirmwareviaUSB
BeforeStarting
 Preparea64MBorlargerUSBstoragedevice.
– MediainsertedinaUSBcardreadermaynotbeusedforthisfunction.
– USBstoragedeviceswithsecurityfunctionarenotsupported.
– USBhubsandUSBdeviceswithhubfunctionarenotsupported.Do
notconnectthesedevicestotheunit.
 DeleteanydatastoredontheUSBstoragedevice.
 Turnoffthecontrollercomponent(PCetc.)connectedtothenetwork.
 StopanyplayingInternetradio,USBstoragedevice,orservercontent.
 Ifthemultizonefunctionisactive,pressOFFonthemainunittoturnit
off.
 If"HDMICEC(RIHD)"issetto"On",setitto"Off"(defaultvalue).
– AfterpressingRECEIVERontheremotecontroller,pressSETUP.
Then,afterselecting"6.Hardware""HDMI"andpressingENTER,
select"HDMICEC(RIHD)"toselect"Off".
＊ SomeUSBstoragedevicesmaytakelongtoload,maynotbeloaded
correctly,ormaynotbecorrectlyfeddependingonthedeviceortheir
content.
＊ Onkyowillnotbeliablewhatsoeverforanylossordamageofdata,or
storagefailurearisingfromtheuseoftheUSBstoragedevicewiththis
AVreceiver.Thankyouforyourunderstanding.
＊ Thedescriptionmaydifferfromtheonscreendisplaybutthatwillnot
changethewaytooperateorthefunction.
Update
1. ConnecttheUSBstoragedevicetoyourPC.
2. DownloadthefirmwarefilefromtheOnkyowebsitetoyourPCandunzip.
Firmwarefilesarenamedinthefollowingway:
ONKAVR＊＊＊＊_＊＊＊＊＊＊＊＊＊＊＊＊.zip
UnzipthefileonyourPC.Thenumberofunzippedfilesandfolders
variesdependingonthemodel.
3. CopyallunzippedfilesandfolderstotherootfolderoftheUSBstorage
device.
 Makesuretocopytheunzippedfiles.
Firmware Update