Onkyo TX-NR545 - Page 134

4. ConnecttheUSBstoragedevicetotheUSBportoftheunit.
 IfyouconnectaUSBharddiskdrivetotheUSBportoftheunit,we
recommendthatyouuseitsACadaptertopowerit.
 IftheUSBstoragedevicehasbeenpartitioned,eachsectionwillbe
treatedasanindependentdevice.
5. AfterpressingRECEIVERontheremotecontroller,pressSETUP.
TheSetupmenuisdisplayedontheTVscreen.
6. Withthecursors,select"8.Miscellaneous""FirmwareUpdate""Update
viaUSB",andthenpressENTER.
 If"FirmwareUpdate"isgrayedoutandcannotbeselected,waitfora
whileuntilitstartsup.
 Youwillnotbeabletoselect"UpdateviaUSB"ifthereisnothingto
update.
7. PressENTERwith"Update"selectedtostartupdate.
 Duringtheupdate,theTVscreenmaygoblackdependingonthe
updatedprogram.Inthatcase,checktheprogressonthedisplayof