Onkyo TX-NR545 - Service Information Mode

Selectthecrossoverfrequencyfrom"40Hz"to"200Hz"tostart
outputtingfrequenciesforeachchannel.
"FullBand":Fullbandwillbeoutput.
 "FullBand"canbeselectedonlywhen"Front"issetto"FullBand".
 Ifanitemcannotbeselectedeventhoughconnectioniscorrect,
checkthatthesettingsin"Configuration""SpeakerChannels"
matchesthenumberofconnectedchannels.
Surround
DefaultValue:100Hz
 Selectthecrossoverfrequencyfrom"40Hz"to"200Hz"tostart
outputtingfrequenciesforeachchannel.
"FullBand":Fullbandwillbeoutput.
 "FullBand"canbeselectedonlywhen"Front"issetto"FullBand".
 Ifanitemcannotbeselectedeventhoughconnectioniscorrect,
checkthatthesettingsin"Configuration""SpeakerChannels"
matchesthenumberofconnectedchannels.
Back
DefaultValue:100Hz
Selectthecrossoverfrequencyfrom"40Hz"to"200Hz"tostart
outputtingfrequenciesforeachchannel.
"FullBand":Fullbandwillbeoutput.
 Thiscannotbeselectedinthefollowingconditions.
– Thesettingfor"Configuration""BiAmp"is"Yes"
– "Configuration""PoweredZone2"issetto"Yes"andZONE2is
on
 "FullBand"canbeselectedonlywhen"Surround"issetto"Full
Band".
 Ifanitemcannotbeselectedeventhoughconnectioniscorrect,
checkthatthesettingsin"Configuration""SpeakerChannels"
matchesthenumberofconnectedchannels.
LPFofLFE
DefaultValue:120Hz
SetthelowpassfilterforLFE(lowfrequencyeffect)signalsinorderto
passlowerfrequencysignalsthanthesetvalueandthuscancel
unwantednoises.Thelowpassfilterwillbeeffectiveonlyonsources
withLFEchannel.
Thevaluefrom"80Hz"to"120Hz"canbeset.
"Off":Donotusethisfunction
DoubleBass
DefaultValue:On