Onkyo TX-NR545 - If an Error Message Is Displayed

2. Withthecursors,select"8.Miscellaneous""FirmwareUpdate""Update
viaNET",andthenpressENTER.
 If"FirmwareUpdate"isgrayedoutandcannotbeselected,waitfora
whileuntilitstartsup.
 Youwillnotbeabletoselect"UpdateviaNET"ifthereisnothingto
update.
3. PressENTERwith"Update"selectedtostartupdate.
 Duringtheupdate,theTVscreenmaygoblackdependingonthe
updatedprogram.Inthatcase,checktheprogressonthedisplayof
theunit.TheTVscreenwillremainblackuntiltheupdateiscomplete
andthepoweristurnedonagain.
 "Completed!"isdisplayedwhentheupdateiscomplete.
4. Press ON/STANDBYonthemainunittoturntheunitintostandby
mode.Theprocessiscompletedandyourfirmwareisupdatedtothe
latestversion.
 Donotuse RECEIVERontheremotecontroller.
IfanErrorMessageisDisplayed
Whenanerroroccurs,"＊＊＊Error!"isdisplayedontheunit.("＊"
representsanalphanumericcharacter.)Checkthefollowing:
ErrorCode
 ＊01,＊10:
Ethernetcablenotfound.ConnecttheEthernetcableproperly.