Onkyo TX-NR545 - Audio

Audio
 Makesurethatthespeakersetupmicrophoneisnotstillconnected.
 Checkthattheoutputjackoftheconnectedequipmentandtheinputjack
ofthisunitareconnectedcorrectly.
 Makesurethatnoneoftheconnectingcablesarebent,twisted,or
damaged.
 IftheMUTINGindicatoronthedisplayflashes,pressMUTINGonthe
remotecontrollertounmutetheunit.
 WhileheadphonesareconnectedtothePHONESjack,nosoundis
outputfromthespeakers.
 If"AudioSelect""PCMFixedMode"issetto"On",setitto"Off".
Iftheabovedoesnotsolvetheproblem,checkthefollowing.
Thereisnosoundfromthetelevision
Thereisnosoundfromtheconnectedplayer
Oneofthespeakersproducesnosound
Onlythefrontspeakersproducesound
Onlythecenterspeakerproducessound
Thesurroundspeakersproducenosound
Thecenterspeakerproducesnosound
Nosoundfromthebackspeakersandheightspeakers
Thesubwooferproducesnosound
Volumeislow
Noisecanbeheard
ThesoundchangeswhenIconnectmyheadphones
AboutDTSsignals
ThebeginningofaudioreceivedbyanHDMIINcannotbeheard
Troubleshooting