Onkyo TX-NR545 - Remapping the Colored Buttons

remotecontrolcodefails.Tryprogrammingagain.
RemappingtheColoredButtons
ThecoloredbuttonassignmentontheAVreceiver'sremotecontrollercanbe
remappedtomatchthatontheremotecontrollerofthecomponentwhose
remotecontrolcodeyouprogrammedtoREMOTEMODE.However,youwill
notbeabletoremapthecoloredbuttonsifZone2isselected.
1. HolddowntheREMOTEMODEbuttontomapandA(Red)
simultaneouslyuntiltheremoteindicatorlights(about3seconds).
 Remappingispossibleonlyforcodesincludedinthecategoriesofthe
RemoteControlCodeList(DVDplayer,TV,etc.)
2. Within30seconds,pressthecoloredbuttonsfromlefttoright,inthe
orderyouwanttoremap.
 Forexample,ifthecoloredbuttonsontheremotecontrollerofthe
othercomponentareyellow,green,blue,andredfromlefttoright,
pressthebuttonsontheAVreceiver'sremotecontrollerinthatorder.
 Programmingiscompletewhentheremoteindicatorflashestwice.
Theremoteindicatorflashesonceslowlywhenprogrammingthe
remotecontrolcodefails.Tryprogrammingagain.
 Pressinganyotherbuttonthanacoloredbuttoncancelstheremap
operation.
ResettingtheREMOTEMODEButtons