Onkyo TX-NR545 - There Is no Picture from a Source Connected to an HDMI in

ThereisnopicturefromasourceconnectedtoanHDMIIN
 Theinputselectorofthisunitneedstobeinthepositionthatcorresponds
tothejackwheretheplayerisconnected.
 WhilethePureAudio(European,AustralianandAsianmodels)listening
modeisselectedonlyvideosignalsinputthroughHDMIINcanbeoutput.
 Checkif"ResolutionError"isdisplayedonthemainunitdisplaywhen
videoinputviaHDMIINjackisnotdisplayed.Inthiscase,theTVdoes
notsupporttheresolutionofthevideoinputfromtheplayer.Changethe
settingontheplayer.
 ReliableoperationwithanHDMItoDVIadapterisnotguaranteed.In
addition,videosignalsfromaPCarenotsupported.
 TryswitchingofftheDeepColorfunction.ToturnofftheDeepColor
function,simultaneouslypresstheSTRMBOXand ON/STANDBY
buttonsonthemainunit.WhileholdingdownSTRMBOX,press
ON/STANDBYrepeatedlyuntil"DeepColor:Off"appearsonthedisplay.
ToreactivatetheDeepColorfunction,repeattheabovedescribedstep
until"DeepColor:On"isappearedonthedisplay.
Troubleshooting