Onkyo TX-NR545 - Resetting the Unit; How to Reset the Remote Controller

Resettingtheunit
Resettingtheunittothestatusatthetimeofshipmentmaysolvethe
problem.Ifthemeasuresmentionedinthetroubleshootingdonotsolvethe
problem,resettheunitwiththefollowingprocedure.Ifyouresettheunit
status,yourpreferenceswillberesettothedefaults.Notethemdownbefore
startingreset.
Howtoreset
1. WhileholdingdownCBL/SATonthemainunit(notethatstep2mustbe
performedwiththisbuttonpresseddown)
2. Press ON/STANDBYonthemainunit."Clear"isappearedonthe
displayandtheunitwillenterstandbymode.
Howtoresettheremotecontroller
1. Whileholdingdown1 RECEIVERontheremotecontroller(notethat
step2mustbeperformedwiththisbuttonpresseddown)
2. Pressandhold2 Qfor3ormoresecondsuntilthe3 remoteindicator
stayslit.Within30seconds,press1 RECEIVERagain.
Troubleshooting