Onkyo TX-NR545 - Page 179

RemoteController
 Makesurethatthebatteriesareinstalledwiththecorrectpolarity.
 Installnewbatteries.Donotmixdifferenttypesofbatteries,oroldand
newbatteries.
 Makesurethattheremotecontrollerisnottoofarawayfromtheunit,and
thatthereisnoobstructionbetweentheremotecontrollerandtheremote
controlsensoroftheunit.
 Makesurethattheunitisnotsubjectedtodirectsunshineorinvertertype
fluorescentlights.Relocateifnecessary.
 Iftheunitisinstalledinarackorcabinetwithcoloredglassdoorsorifthe
doorsareclosed,theremotecontrollermaynotworkreliably.
Iftheabovedoesnotsolvetheproblem,checkthefollowing.
Theremotecontrollerdoesnotwork
OperatingotherOnkyocomponentbyusingaRIremotecontrolcodeis
notavailable
CannotoperateOnkyocomponents(oneswithoutRIconnection)and
componentsofothermakers
Troubleshooting