Onkyo TX-NR545 - Page 181

OperatingotherOnkyocomponentbyusingaRIremotecontrolcodeis
notavailable
 MakesurethattheOnkyocomponentisproperlyconnectedwithRI
cable.WhenRIcableisusedforconnection,makesuretoconnect
analogaudiocableaswell.(ConnectingonlyanRIcablewillnotbe
enough.)
 Makesureyouhaveselectedthecorrectremotecontrollermode.
 WhentheRIremotecontrolcodeisinput,pointtheremotecontrollerat
remotecontrolsensoroftheunit.
 Makesurethattheinputdisplayiscorrectlyset.
 InputtheRIremotecontrolcodeagain.
Troubleshooting