4. To select a filesystem from an available source drive, tap the 2 or Source
heading. A list of attached drives will appear, with a filesystem summary tile
shown under each drive for any filesystems recognized by TX1. Note that
network shares can also be used as logical image job sources. To make a network
share visible in the Select a source list, tap the orange plus button
at the top
right of the modal and follow the share mounting workflow. Source network
shares can be mounted from the Sources button on the main screen as well.
Once the source drive/share list is set, simply tap the desired filesystem tile to
select it as the source for the logical image job. A green check confirms your
selection and the source selection modal will auto-close. If a different source
filesystem is desired (or to verify the details of the selected filesystem), simply go
back into the Select a source screen by tapping the 2 or Source heading from the
logical image job setup stepper. Close the modal by tapping the X in the upper
right corner or by tapping outside of the modal.
Note: Within any screen displaying a list of drives, you can tap the options
icon (three vertical dots) located on the right side of the drive tile to see
more drive detail and access any available media utilities.
Chapter 4 Using TX1
120
OpenText™ Tableau™ Forensic TX1 Imager
ISTX240300-UGD-EN-1
To Next Page
Loading...
