Note: Unlike a physical duplication job, the option of shelving a source
drive DCO/AMA (removing it and then re-applying it at the end of the job)
does not exist in logical imaging. The existence of a DCO or AMA will be
obvious (per warnings in multiple locations), but the DCO/AMA will need
to be permanently removed using the manual HPA/DCO/AMA Disable
media utility before gaining access to all portions of the source media.
5. The next step is to determine which files and folders should be acquired. Start
this process by tapping the 3 or Files to Acquire heading in the job setup stepper
(resulting in the screen shown below). The default setting is to acquire all files
and folders. Use the default setting if your job does not benefit from targeted
down-selection of source files/folders and skip to the Destination(s) selection
step below.
4.5. Logical imaging
ISTX240300-UGD-EN-1
User Guide
121
To Next Page
Loading...
