actual backup files. The default value is “image” or whatever is set for Image
name in the Defaults setting area. To change the default image name, tap into
the Image name field. See “Files created during mobile backup acquisition”
on page 162 for more information on the folders and files created during a
mobile acquisition job.
• File size: This setting only applies if Lx01 is selected for the File output
setting. It sets the size of the Lx01 segment files that will be written to the
destination. Note that the size of the files captured in Native format are
determined by the mobile device. The Lx01 segment file size options are: 2
GB, 4 GB, 8 GB, and Unlimited. The default value is 2 GB or whatever is set
for File size in the Defaults setting area.
• Compression: This setting only applies if Lx01 is selected for the File output
setting. If enabled, the data will be compressed as it is written out to the Lx01
segment file(s) to help minimize the overall size of the output file set. The
default setting is enabled.
• Readback verification: This setting only applies if Lx01 is selected for the
File output setting. If enabled, the acquired files in the Lx01 segments will be
read back from the destination and hashed, and then those hashes will be
compared to the original acquisition file hashes. The default value is enabled
or whatever is set for Readback verification in the Defaults setting area
7. Once you are satisfied with your settings and device/drive selections, tap the
Start Mobile Backup Acquisition button. A Job Status screen is automatically
displayed, as shown below.
Chapter 4 Using TX1
160
OpenText™ Tableau™ Forensic TX1 Imager
ISTX240300-UGD-EN-1
To Next Page
Loading...
