C200 SOFTWARE
Instruction Manual C200 Part2 A1.doc
optek Danulat GmbH • D-45356 Essen • Germany
page 21
Note. The menu displayed when pressing the MENU key from the Operator View pages depends on analyzer
configuration, i.e.:
Single Input Analyzers
Probe Type set to pH
or
Probe Type set to Redox or ORP and Enable Cals set to Yes (Section 5.1.3) – see Section 4.1.
Probe Type set to Redox or ORP and Enable Cals set to No (Section 5.1.3) and Alter Sec. Code
not set to zero (Section 5.1.8) – see Section 5.1.
Probe Type set to Redox or ORP and Enable Cals set to No (Section 5.1.3) and Alter Sec. Code
set to zero (Section 5.1.8) – see Section 5.1.2.
Dual Input Analyzers
Probe Type for either sensor set to pH
or
Probe Type for both sensors set to Redox or ORP and Enable Cals for either sensor set to Yes
(Section 5.1.3) – see Section 4.1.
Probe Type for both sensors set to Redox or ORP and Enable Cals for both sensors set to No
(Section 5.1.3) and Alter Sec. Code not set to zero (Section 5.1.8) – see Section 5.1.2
Probe Type for both sensors set to Redox or ORP and Enable Cals for both sensors set to No
(Section 5.1.3) and Alter Sec. Code set to zero (Section 5.1.8) – see Section 5.1.2
To Next Page
Loading...
