Troubleshooting
7-20 StorageTek SL150 Modular Tape Library User's Guide
3. Align the Allen wrench parallel to the magazine face and slowly push it into the
hole.
The internal magazine latch unlocks.
4. Grasp the handle on the front of the magazine and slowly and gently pull the
magazine a short distance out of the library.
5. Remove the wrench.
Locate and Remove a Cartridge that is Stuck in a Magazine Slot
If the Library Health table lists an event with fault code 9108 and includes one or more
magazines in the Suspect Components field for the event, a cartridge is probably stuck
in a storage cell.
WARNING: Oracle's StorageTek SL150 Modular Tape Library
contains a Class-1 laser, as defined by IEC 60825-1 Ed. 2 (2007). Use
of controls or adjustments or performance of procedures other than
those specified herein may result in hazardous radiation exposure.
To locate and correct the problem, proceed as follows:
1. Identify the problem slot. Correlate the details of the failed move, as listed in the
Library Activity Panel, with the Suspect Components field of the corresponding
Library Health record.
2. Unlock the magazine that contains the problem. Use the procedure "Remove
Magazines from a Non-Operational Li
brary" on page 7-19.
3. Support the bottom of the magazine with one hand, grasp the front handle with
the other, and slowly and gently pull the magazine out of the module.
4. If you feel any significant resistance when you try to remove the magazine, stop
and check for obstructions. Go to "Locate and Clear Obstructions, Such as Loose or
Protruding Cartridges" on page 7-21.
5. Set the magazine on a flat, stable, uncluttered surface, taking care so that
cartridges do not spill out.
6. Locate the slot that appears to hold the stuck cartridge. Grasp the cartridge by the
top and bottom gripping surfaces, and see if it moves freely.
To Next Page
Loading...
