Using Simple Network Management Protocol (SNMP)
7-12 StorageTek SL150 Modular Tape Library User's Guide
14. To change the SNMP v3 data-protection password, enter the changes into the
Privacy Passphrase text field.
15. If you must change the SNMP v3 agent identifier, enter the changes in the Engine
ID field. Your entry must be a hexadecimal value that starts with
0x
and does not
contain either all zeroes (
0
) or all sixteens (
F
).
16. To close the dialog without adding the SNMP trap recipient, press Cancel.
17. To delete the SNMP trap recipient and close the dialog, press OK.
Delete an SNMP Trap Recipient
To remove an SNMP management station from the trap recipients list, proceed as
follows:
1. Select SNMP from the menu on the left side of the interface.
The tabbed SNMP property sheet appears.
2. Select the SNMP Trap Recipients tab.
3. Click on Delete Trap Recipient in the control bar above the table.
The Delete Trap Recipient dialog appears.
4. To close the dialog without deleting the SNMP trap recipient, press Cancel.
5. To delete the SNMP trap recipient and close the dialog, press OK.
Send a Test Trap
To test your SNMP configuration, proceed as follows:
1. Select SNMP from the menu on the left side of the interface.
The tabbed SNMP property sheet appears.
2. Select the SNMP Trap Recipients tab.
3. Click on Se nd a Test Tra p in the control bar above the table.
The Send a Test Trap dialog appears.
If the Send a Test Trap button is grayed out, SNMP is disabled and the dialog does
not appear. So enable SNMP.
4. To close the dialog without sending the SNMP test trap, press Cancel.
5. To send an SNMP level 13 test trap to all configured recipients and close the
dialog, press OK.
Download the Management Information Base (MIB)
You can download the management information base (MIB) using the procedure
below:
1. Select SNMP from the menu on the left side of the interface.
The tabbed SNMP property sheet appears.
2. Click the Download Mib button at the top of the property sheet.
3. When the download dialog appears, save the file or view it in an editor.
The file is named
STREAMLINE-TAPE-LIBRARY-MIB.txt
.
To Next Page
Loading...
Need help?
General