Setting the Time, Network Address, and Library Parameters
System Configuration 4-5
2. In the Date (mm/dd/yyyy) field, enter the date using the format
mm/dd/yyyy
,
where:
■
mm
is the month, a two-digit number in the range [
01-12
]
■
dd
is the day of the month, a two-digit number in the range [
01-31
]
■
yyyy
is the year, a four-digit number
■
/
is the field delimiter.
3. In the Time (hh:mm:ss) field, enter the time using the format
hh:mm:ss
, where:
■
hh
is the hour, a two-digit number in the range [
00-23
]
■
mm
is the minute, a two-digit number in the range [
00-59
]
■
ss
is the second, a two-digit number in the range [
00-59
]
■
:
is the field delimiter.
4. If you do not wish to proceed, press Previous to go back one screen or Cancel to
quit.
5. Press the Next button to proceed.
6. If you checked the Configure Library Settings checkbox, configure library
settingsnow.
7. Otherwise, if you are finished, review and apply the configuration changes.
Set the Date and Time Using NTP
1. To set the date and/or time automatically using NTP, select Using Network Time
Protocol from the Configure Date and Time list box.
2. In the NTP Server 1 field, enter the Internet Protocol (IP) address of a Network
Time Protocol server on your network.
3. In the remaining NTP server fields, you may enter Internet Protocol (IP) addresses
for up to two more NTP servers, if desired.
4. If you do not wish to proceed, press Previous to go back one screen or Cancel to
quit.
5. Press the Next button to proceed.
6. If you checked the Configure Library Settings checkbox, configure library settings
now.
7. Otherwise, if you are finished, review and apply the configuration changes.
Configure Library Settings
1. If you have not already done so, run the configuration wizard. Check the
Configure Library Settings checkbox.
The Configure Library Settings worksheet appears.
2. In the Drive Element Addressing Mode field, set the list control to Address All
Drive Slots (Recommended) or Address Only Installed Drives.
Address All Drive Slots (Recommended) assigns new SCSI hardware addresses
to all drive bays in the library, whether or not drives are actually installed. The
correct setting for your system depends on your current configuration:
To Next Page
Loading...
