Oracle storagetek sl150 User Manual

Setting the Time, Network Address, and Library Parameters
4-4 StorageTek SL150 Modular Tape Library User's Guide
7. If you do not wish to proceed, press Previous to go back one screen or Cancel to
quit.
8. Press the Next button to proceed.
9. When the Configure Port 2 screen appears, enable or disable Service Network
Access on Port
2.
Enable or Disable Service Network Access on Port 2
On the SL150 Modular Tape Library, Network Port 2 is reserved for service use. You
cannot change the IP address. But you can enable or disable the port as required.
Proceed as follows:
1. To allow service access to Port 2, select Enabled from the Network Port 2 list
menu.
2. To block service access to Port 2, select Disabled from the Network Port 2 list
menu.
3. If you do not wish to proceed, press Previous to go back one screen or Cancel to
quit.
4. Press the Next button to proceed.
5. If you checked the Set the Library Date and Time checkbox when the
Configuration Wizard started, set the library date and time now.
6. Or, if you checked the Configure Library Settings checkbox when the
Configuration Wizard started, configure library settings now.
7. Otherwise, if you are finished, review and apply the configuration changes.
Set the Library Date and Time
To set the time, do the following:
1. If you have not already done so, run the configuration wizard. Check the Set the
Library Date and Time checkbox.
The Set the Library Time Zone worksheet appears.
2. Next, set the library time zone.
3. Then, either set the date and time locally or use Network Time Protocol (NTP).
Set the Library Time Zone
1. When the Set the Library Time Zone worksheet of the Configuration Wizard
appears, select a Time Zone from the first list box.
2. Select a Closest City of Region from the second list box.
3. If you do not wish to proceed, press Previous to go back one screen or Cancel to
quit.
4. Press the Next button to proceed.
5. Next, either set the date and time locally or use Network Time Protocol (NTP).
Set the Date and Time Locally
1. To set the date and/or time locally, select Manually from the Configure Date and
Time list box.

Oracle storagetek sl150 Specifications

General

Brand	Oracle
Model	storagetek sl150
Category	Storage
Language	English