No. P10355
|13|
7. TRANSPORT AND INSTALLATION
7.1 Transport
WARNING
Follow the instructions below to avoid trouble and product damage when carrying the welding
machine.
Do not touch the charging parts inside or outside the welding machine.
Be sure to disconnect the line disconnect switch when carrying the welding
machine.
When hanging the welding power source by a crane, do not use the carrying
handle.
7.2 Installation
WARNING
When installing the welding machine, follow the instructions below to avoid a fire caused by
welding and physical damages by fume gas.
Do not place the welding machine near combustible materials and flammable
gas.
Remove combustible materials to prevent dross coming into contact with
combustible objects. If that not possible, cover them with noncombustible
covers.
To avoid gas poisoning and danger of suffocation, wear a gas mask or
adequately ventilate when the welding machine is used in the place regulated
by a local law.
To prevent disorder or poisoning caused by fume, wear a gas mask or weld at
a partial exhaust facility approved by the local regulation.
Adequately ventilate or wear a gas mask when using the welding machine in a
tank, a boiler, a hold of a ship, because heavier gas such as carbon dioxide or
argon gases are drifting there.
When using the welding machine at a narrow space, comply with a trained
supervisor’s directions. And be sure to wear a gas mask.
Do not operate the welding machine near the place where degreasing,
cleansing, and spraying are performed. Otherwise, poisonous gas may be
generated.
Be sure to wear a gas mask or adequately ventilate when welding a coating
steel plate. (Poisonous gas and fume may be generated.)
To Next Page
Loading...
