OTC DP-400 - Control Cable for Wire Feeder (10 P); Extension Cable;Hose (Extension of Work Space); Gas Hose; Power Cable (for Torch and for Base Metal)

No. P10355
 |64 |
11. APPLIED FUNCTION (continued)
11.4.2 Extension Cable/Hose (Extension of Work Space)
CAUTION
 
Do not connect an unnecessarily long extension cable.
 
When using an extension cable, roll it out. Failure to observe the demand may result
in unstable arc.
Choose a proper torch cable (separately sold) for work space. When extending the work
space, use other extension cables/hoses (separately sold ) that match the work space.
1. Power Cable (for torch and for base metal)
5m 10m 15m 20m
Mode
l
BKPDT-6007 BKPDT-6012 BKPDT-8017 BKPDT-8022
AWG2/0 (60mm
2
) AWG3/0 (80mm
2
)
2. Gas Hose
5m 10m 15m 20m
Mode
l
BKGG-0605 BKGG-0610 BKGG-0615 BKGG-0620
3. Control Cable for Wire Feeder (10 P)
5m 10m 15m 20m
Mode
l
BKCPJ-1005 BKCPJ-1010 BKCPJ-1015 BKCPJ-1020
4. Control Cable for Analog Remote Control (6P)
5m 10m 15m 20m
Model BKCPJ-0605 BKCPJ-0610 BKCPJ-0615 BKCPJ-0620
5. Water Hose (for feeding water and condensed water)
5m 10m 15m 20m
Model BKWR-0605 BKWR-0610 BKWR-0615 BKWR-0620
* A water cooler and water hoses are necessary for use of a water-cooled torch.
*
Analog remote control
(Optionally available)
Welding power source
Wire feeder
Control cable for wire feeder
Gas hose
Power cable for wire feeder
@
A
C
B
Control cable for remote control