OTC DP-400 - Operation Flow in the Memory Mode; Operation Flow in the Readout Mode

No. P10355
 |53 |
10. OPERATION (continued)
x
Operation flow in the memory mode
x
Operation flow in the readout mode
Press the LOAD key.
Set the welding condition number while
turning the parameter adjusting knob.
Press the DISPLAY CHANGE key
to check the parameter value.
Press the ENTER key.
The readout mode quits
.
The welding conditions are preset to the number you selected.
Discontinue
Reset the welding condition number.
Press the ENTER key.
Press the SAVE key.
Press the LOAD key.
Discontinue
Press the MEMORY key.
Set the welding condition number while
turning the parameter adjusting knob.
Press the DISPLAY CHANGE key
to check the parameter value.
Press the ENTER key.
The memory mode quits
.
The welding conditions are preset to the number you selected.
Discontinue
Reset the welding condition number.
Press the ENTER key.
Press the LOAD key.
Press the MEMORY key.
Discontinue