No. P10355
|
10. OPERATION (continued)
10.1.2 Setting the Parameter (continued)
(1) Pre-flow Time Setting
Once the pre-flow time is chosen, the setting value is displayed in the left display and the
"sec." lamp lights. At this condition, you can set pre-flow time while turning the parameter
adjusting knob [6]. The setting range of pre-flow time covers 0 second to 10 seconds.
(2) Setting of the Initial Conditions
The initial conditions can be chosen only when initial current is set to ON. Once the initial
conditions are chosen, the setting values of initial conditions are displayed in the displays.
(3) Setting of the Main Conditions
Once the main conditions are chosen, the setting values of the main conditions are
displayed in the displays.
(4) Setting of the Crater Conditions
Only for ON (-) or ON ( ), the crater conditions can be selected. Once crater conditions
are chosen, the setting values of the crater conditions are displayed in the display.
(5) Setting of the Post-flow Time
Once the post-flow time is selected, the setting value is displayed in the right display and
the "sec." lamp lights up. At this conditions, the post-flow time can be set while turning the
parameter adjusting knob [6]. The setting range of post-flow time covers 0 second to 10
seconds.
To Next Page
Loading...
