No. P10355
|42 |
10. OPERATION (continued)
10.1.14
Using the Analog Remote Control K5416H (optional accessory) (continued)
xWhen making the INDIVIDUAL adjustment:
Selecting the "INDIVIDUAL" adjustment allows you to set welding current and welding
voltage individually.
NOTE: INDIVIDUAL adjustment is activated when selecting AL/PURE (SOFT
ALUMINUM) or AL/MG (HARD ALUMINUM). In pulse welding, even when the
INDIVIDUAL adjustment is selected, the scales on the analog remote control may
not correspond with the actual welding current/voltage.
xWhen making the SYNERGIC adjustment:
When selecting the "SYNERGIC" adjustment, welding voltage is automatically adjusted
only by turning the WELDING CURRENT knob [6]. To finely adjust welding voltage, use
the VOLTAGE. knob.
NOTE: It is possible to adjust low-current region, where a small-diameter wire is
used for weld, and to finely adjust welding current by replacing with the full-scale
200A plate (supplied). To replace the scale plate, press the F key [12] and change
the initial value of F9 to 200. Refer to Section 10.2.1(9), “Selection of scale plate of
analog remote control”.
To Next Page
Loading...
