INF-16
<< Hours Meter Reset Procedure >>
1. Press the “EJECT” + “STOP” and “PF” + “MENU” buttons on the Front Panel simultaneously so that
the display shows the “HOURS METER” as shown below.
2. Then move the cursor (*) to the item with “r” to be reset.
3. Press the “RESET” button on the Front Panel so that the display changes as shown below. After the
following confirmation message is displayed, move the cursor (*) to the item to reset by controlling the
Joy Stick. (Only H11 – H14 with “ r ” can be reset.)
4. When confirming the message “* * * * * *r OK?”, press the “PLAY” button on the Front Panel, the data
(***H) for the item where the cursor is located will be reset.
5. Press the “MENU” button simultaneously press the “PF” button so that the VTR returns to the normal
screen.
DIAG-MENU HOURS METER
Ser 0000000001
H00 OPERATION 1000H
H01 DRUM RUN 2000H
H02 TAPE RUN 3000H
H03 THREADING 4000T
H04 F LOADING 4000T
* H11 DRUM RUN r 2000H
H12 TAPE RUN r 3000H
H13 THREADING r 4000T
H14 F LOADING r 4000T
END
HOURS METER INIT SET
DRUM RUN r OK?
To Next Page
Loading...
