Panasonic AJ-SD93P/E - Flash ROM; FPG Software Version Upgrade Procedure

INF-21
FLASH MEMORY VERSION
UP TOOL (VFM1304A)
TO THE CONNECTOR
ON TEH SERVO OR DPROC
BOARD IN THE VTR.
Figure 12-1A-3
12-2. Flash ROM / FPG Software Version Upgrade Procedure
Connect the VTR with personal computer by RS232C cable (Cross cable) and Flash Memory Version-up Tool
(VFK1304A) as shown below.
Figure 12-2A-1
12-2-1. Preparations for the Version Upgrade
1. Items required for flash memory writing
Version Upgrade Software .........................................................VFK1248N or higher
VFK1248N consist of 4 type of software as shown below.
· VSI2312N.exe
· f_servo.obf
· FW103u.exe
· Setting.ini
Personal Computer : WINDOWS95/98
RS-232C Cable (D-sub 25pin-25 pin cross cable or D-sub 9 pin-25 pin cross cable)
Flash Memory Version Up Tool ..................................................VFK1304A
2. Switch setting of the flash memory version upgrade tool
Confirm that the switch settings for the "flash memory version up tool (VFK1304A)" are as shown below.
SW1-1: ON SW1-3: OFF
SW1-2: ON SW1-4: OFF
F5: SDI Board (AJ-YA94) F4: AVIO Board (AJ-YA93G)
RS-232C CROSS CABLE
PC
IC3400
IC255