Panasonic CZ-CFUNC2 - Page 120

ー 118 ー
Operating Instructions Intelligent Controller
144
Conguring the system
Setting
4
Touch [Register].
z To cancel the settings, touch [Cancel].
4
5
Touch [Register].
z To cancel the settings, touch [Cancel].
5
Note
y Do not allocate PAC and GHP to the same area or distribution
groups when using time distribution.
Automatically setting central addresses
1
Put a check mark in the “Register” column.
z Select the indoor units you want to manage.
1
2
Touch [CNTR adr AutSet].
2
Note
y The central address is shared with other centralised
controllers (system controllers, etc.). Do not change unless necessary.
y After setting the central address in the “Edit unit settings”
dialogue, and then enable [CNTR adr AutSet], the central addresses will be overwritten.
Basic settings on the indoor unit
145
Conguring the system
Setting
Basic settings on the outdoor unit Display details about outdoor units (outdoor unit addresses, etc.). Settings such as the names can also be changed.
4
Put a check mark in the “Register” column.
z Select the outdoor units you want to manage.
4
5
Touch [Register].
z To cancel the settings, touch [Cancel].
5
1
Touch [System Settings] in “Settings”.
z The “System settings” screen is displayed.
1
2
Touch [O/D unit settings].
z The “O/D unit settings” screen is displayed.
2
3
Check the setting details (P.146).
TGR-318_ENG.indb 118 2017/04/06 10:44:06