Panasonic CZ-CFUNC2

ー 120 ー
Operating Instructions Intelligent Controller
148
Conguring the system
Setting
Basic settings for distribution calculation Set specied days, cut-off days, particular time slots (regular hour ranges) and days of the week for calculating distributions.
3
Change the settings.
Item Explanation
SpeciedDay- Calendar
Set specied days (days where the whole day will have a special distribution setting, such as holidays, when the time slot doesn’t matter). These can be set starting with the current month and up to 2 years in the future. (→ “Registering specied days” (P.149))
CtffDay Set the monthly cut-off days (“1” to “28”, “End”).
(→ “Registering cut-off days” (P.149))
RglrHourRnge Set the distribution time slots for each day of the
week. Regular hour range settings possible if you put a check mark in “Valid”. The “Regular hour range settings” dialogue is displayed when you touch [RglrHourRnge stngs]. (→ “Set the target time slots for distribution calculation” (P.150))
4
Touch [Register].
z To cancel the settings, touch [Cancel].
4
1
Touch [System Settings] in “Settings”.
z The “System settings” screen is displayed.
1
2
Touch [Calendr sttngs for distr calc].
z The “Calendr sttgs for distr calc” screen is displayed.
2
149
Conguring the system
Setting
Registering specied days
1
Touch the date for the specied day.
z Use to select the registered month. Touch [CMth] to
return to the current month.
z The colour of the date column changes when you touch
this. Touch again to return to the original. You cannot set a date in the past, however.
z Touch the day of the week column to set the specied day
by day of the week.
1
Day of the week column
Registering cut-off days
1
Touch .
z Touch to move the days forward, touch to
move the days back.
1
Basic settings for distribution calculation
TGR-318_ENG.indb 120 2017/04/06 10:44:08