ー 33 ー
Display and settings for the communication adaptor board
Various procedures
(06–03) Clear the physical address of all indoor units of air conditioner linked system 1
(06–04) Clear the physical address of all indoor units of air conditioner linked system 2
•
Press and hold the SET key for at least 1 second on the Physical Address Clear screen and the physical
address of all connected indoor units is cleared.
(06–05) Automatic physical address setting of all indoor units of air conditioner linked system 1
(06–06) Automatic physical address setting of all indoor units of air conditioner linked system 2
•
Press and hold the SET key for at least 1 second on the Physical Address Auto Settings screen and the
physical address of all connected indoor units is automatically set in the order of indoor unit address in the
range of 1 to 64.
* The physical address of already-set units is not changed.
Set unused physical addresses in the order of addresses of unconfigured units.
■ (07)
There is no function for this item.
TGR-318_ENG.indb 33 2017/04/06 10:42:45
To Next Page
Loading...
