405
SEP 2006
Ver. 1.0
DP-8020E/8020P/8016P
(36) Slide the 3rd Paper Tray out of the unit.
(37) Remove 5 Screws.
(38) Separate the 4th Paper Tray from the 3rd Paper
Tray.
(39) Install the Heater, refer to Steps (11) - (21).
(40) Replace the 3rd Paper Tray Unit onto the 4th
Paper Tray Unit.
(41) Secure the 3rd Paper Tray Unit with 5 Screws
(XTW3+6LFJ, XTB3+8GFJ).
(42) Remove the Dummy Plug.
(43) Install 1 Edge Saddle.
(44) Route the PTC-AC Harness 4 through the hole
in the frame as illustrated.
(45) Connect the PTC-AC Harness 4.
(46) Secure the PTC-AC Harness 4 with the Harness
Clamp and Edge Saddle.
(47) Place the 2nd Paper Tray Unit onto the 3rd
Paper Tray Unit.
(48) Secure the 2nd Paper Tray Unit with 5 Screws
(XTW3+6LFJ, XTB3+8GFJ).
To Next Page
Loading...
