Panasonic GM1 Series - The Stopping Position Is off for a Home Return

REFERENCE
4.3 List of Pulse_4Axes Parameters
15.3.6 The Stopping Position is OFF for a Home Return
■
Situation
When a home return is carried out, there is a possibility that the speed cannot be slowed
sufficiently. If deceleration cannot be continued down to the startup speed, the unit will not stop
even if there is home input.
■
Solution 1
Shift the position of the near home input switch in the direction of the home return to the
position in the opposite direction.
■
Points to check
If the home input is connected to the Z phase of the servo amplifier, there may be cases in
which the near home input position is close to the home input.
15.3 What to Do If an Error Occurs
15-6 WUME-GM1PG-01