1. Change the position of the near home input.
2. Reduce the home return speed.
● Deviation may occur depending on the position of the near home input and home input or
the home return speed.
REFERENCE
4.3 List of Pulse_4Axes Parameters
5.4.5 Checking Rotating and Moving Directions and Moving Distance
1. Execute the JOG operation to confirm that the rotating direction and moving direction of the
motor are correct.
● The rotating direction is determined according to the installation of the ball screw or the
“CW/CCW direction setting” option of "Pulse_4Axes Parameters".
2. Confirm whether the moving distance is as designed or not by the position control.
● The moving distance is determined according to the pitch of the ball screw, deceleration
gear ratio, or setting movement amount of the positioning data.
REFERENCE
4.3 List of Pulse_4Axes Parameters
5.4 Confirming while the Power is ON
5-8 WUME-GM1PG-01
To Next Page
Loading...
