AccDec:=10000);
END_CASE
6.1.2 Absolute (Absolute Value Control)
This section describes a program example for specifying absolute (absolute value control) using
the E-point control.
● Use the PG_MoveAbsolute function block.
● Specify the target position in the Position input paraneter and execute the function block. The
table will move to the target position regardless of the current position.
● The following describes an example for moving from the current position (+20000) to a target
position (+30000).
■
Pulse output diagram
6.1 Sample Program
6-4 WUME-GM1PG-01
To Next Page
Loading...
