Panasonic GM1 Series - Overview of PANATERM Lite for GM

4.2 Performing Parameter Settings
Specify operation of the positioning unit by setting parameters.
■
Overview
● After adding a pulse output unit to the project, select the unit from the device pane to set its
parameters.
● The pulse output units are displayed as follows in the device pane.
Pulse output unit (Line driver output type) Slot*_Pulse_4Axes (AGM1PG04L)
Pulse output unit (Transistor output type) Slot*_Pulse_4Axes (AGM1PG04T)
(Note 1) The segments indicated by * differ according to the expansion location.
Changing parameters of the pulse output unit connected to the 1st unit
1. Double-click " Slot1_Pulse_4Axes（AGM1PG04L）" in the device pane.
2. Click the "Pulse_4Axes Parameters" tab.
3. Change the Parameter for every channel.
Parameter setting example
(Note 1) In this example, the pulse input mode for the 3rd axis is set to "Direction distinction input".
● For the description of parameters to be set, see the next page.
4.2 Performing Parameter Settings
WUME-GM1PG-01 4-5