Panasonic GM1 Series - Movement Does Not Stop at Home Position (after Decelerating for Home Return)

REFERENCE
4.3 List of Pulse_4Axes Parameters
15.3.8 Movement Does Not Stop at Home Position (after decelerating for
home return)
■
Situation
There is a possibility that the PG_Home has not been executed correctly.
■
Solution 1
Forcibly turn the home input sensor ON and OFF from an external source, and check to see if
the home input display LED "Z" on the pulse output unit lights.
■
Solution 2
Check to see if the input valid logic for the home input is normally either ON or OFF.
■
Solution 3
● Check the parameter for home return.
● As a default, the home input is set to "NC contact". When the home input is not connected,
the unit processes as the home input is invalid.
REFERENCE
4.3 List of Pulse_4Axes Parameters
15.3 What to Do If an Error Occurs
15-8 WUME-GM1PG-01